This week not much work on the Lab nor UE5… But this week I focused mainly on ZBrush hard-surface modeling working on practice exercises
These were my week’s sketches I made while I went to the coffee shop
From the sketches I decided to model the baton looking tool
Going to work on modeling this later this week. see how it goes
For this week though, I 3d printed a barricade model I made based on the one I found outside during my drive. (Albeit it’s missing the side hooks, if the model looks good, can work on adding those to make a chain of these…) Also ordered some sanding pads, paint and decals which will come later this week fingers crossed to start giving it a finished look
They came out tinier than I expected in my first run…….
For that a reason a *jumbo* print was made, still waiting on that to finish printing, will post here eventually alongside the baton concept
aonepathan blog 